daughter porno moviesSometimes you have the need for?a device that . This time we?were in need of a small embedded device that could power on a computer over a LAN cable.
daughter porno moviesLuckily there is already a well established standard called Wake On Lan.
This standard works by sending a “magic packet” over?the network. When the network card in the target computer recognizes this packet, it powers on the machine. I could not find a small unit that could send this magic packet without the need of a full blown computer (or a board such as Raspberry Pi). We?just want a simple button that could send a magic packet and therefore we?made one ourself.
Luckily we?had a iMCU7200EVB development board from WIZNet laying around. This board have an “iMCU” called W7200. It’s simply an W5200 TCP/IP Ethernet controller chip and a STM32F103 MCU in the same physical package. Unfortunately the W7200 is now obsolete. But since this is based on the W5200 chip and Cortex M3, this should be possible to port to other MCUs.
In addition to the?development board, the only other hardware needed is casing, button and a power connector. All of the parts were of course old stuff?that we had laying around (discovered here). As a result of that does?the casing looks pretty retro!
Firmware wise the code is a modified version of an app note WIZNet originally made.
Their implementation of Wake On LAN were partially wrong?:/?Their implementation did only send 6 bytes with the value 255, followed by sixteen repetitions of the target MAC address.
This is correct according to the minimal?Wake On LAN specification, but in our?experience some computers need a magic packet with a complete Ether frame structure with correct EtherType?set (this is 0x0842 for Wake On LAN).
Our?implemented packet structure
Destination MAC + Source MAC + EtherType + Magic Packet Frame (6 bytes of 255 followed by 16 repetitions of destination MAC)? + CRC
Actually we?skipped the CRC calculation… Since the packet is decoded in HW (in the Ethernet card) we thought that if the Ethernet processor have matched the ether frame and the 16 repetitions it does not care about the CRC.
And as we?thought this seems to be correct, at least on all of our?computers that we have available here. And if we suddenly are going to use the button with a computer that does need the CRC it’s easy to add this at a later point.
We?also made the firmware to only send packets when the?button is pressed. Further?we?implemented sleep mode when the MCU does not send any packets, resulting in a power saving sleep mode for most of the time ?
Just for illustrative purposes, here is a code snippet of the code that enters sleep mode after the module has sent the magic packet:
SysTick->CTRL&= ~SysTick_CTRL_TICKINT_Msk;// systick IRQ offPWR_ClearFlag(PWR_FLAG_WU);PWR_EnterSTOPMode(PWR_Regulator_LowPower, PWR_STOPEntry_WFI);SysTick->CTRL|= SysTick_CTRL_TICKINT_Msk;// systick IRQ on
Because this were only a “one night”-project, the firmware is?not that pretty. Therefore?we?will not give out the complete code (code quality check failed…:P), but if you are interested in making your own we?will gladly send you the code if you contact us!